MV Agusta F4 BRUTALE 750 ORO Workshop Manual page 43

Maintenance
Remove the secondary air blade from the head cover,
only if inspection is necessary.
B
Operating as shown in the figure, slightly lift up the
cylinder head cover.
To carry out this operation, use only the work surfaces
indicated.
Take care to not ruin or deteriorate the motorcycle
parts in the proximity of the work area.
Proceed with the removal of the cylinder head cover.
To facilitate this operation, it is advisable to move the
rubber engine coolant filling tube situated on the left
side of the motorcycle.
Complete the removal of the cylinder head cover by sli-
ding it towards the rear part of the motorcycle.
- 27 -