Stubborn Soiling On The Flexiclip Telescopic Runners; Cleaning The Catalytic Enamelled Back Panel; Removing Soiling Caused By Spices, Sugar And Similar Deposits - Miele H6160B Operating And Installation Instructions

Stubborn soiling on the
FlexiClip telescopic runners
Do not clean FlexiClip telescopic
runners in a dishwasher. The special
lubricant used in the telescopic
runners will wash out during
dishwashing.
In the case of stubborn soiling on the
surfaces of the telescopic runners, or
clogged bearings caused by fruit juices
spilling over, proceed as follows:
^ Soak the FlexiClip runners for approx.
10 minutes in a solution of hot water
and washing-up liquid. If necessary,
use the back of a washing-up
sponge to remove the soiling. The
bearings can be carefully cleaned
with a soft brush.
The runners may appear discoloured
or a lighter colour in places after they
have been cleaned. This will not
affect the functioning of the runners
in any way.
Cleaning and care
Cleaning the catalytic
enamelled back panel
Soiling from oil and fat is burnt off
catalytic enamel when very high
temperatures are used in the oven.
The higher the temperature, the more
effective the process.
Exposure to scouring agents,
abrasive brushes or sponges and
oven sprays can cause catalytic
enamel to lose its self-cleaning
properties.
Catalytic enamelled panels should
therefore be taken out of the oven
before using oven spray in it.
Removing soiling caused by spices,
sugar and similar deposits
^ Remove the back panel (see
"Cleaning and care - Removing the
back panel").
^ Clean the back panel by hand with a
solution of hot water and washing-up
liquid applied with a soft brush.
^ Rinse it thoroughly and then leave it
to dry before fitting it back in the
oven.
89