Titan 110/ 165 Operation and Maintenance Manual
c) Raise the front safety shield, remove the
pressure plate and the feed table.
d) Use the rubber cement eraser to clean the nip
rollers.
Excessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
© GBC Films Group November 2000
CAUTION
e ) Replace the feed table and lower the front
safety shield.
INFORMATION
Locator latches on the pressure plate are
not associated with an interlock switch.
The laminator will operate without
the pressure plate installed.
f) Press
.
REVERSE
Maintenance
Page 8 - 5