GBC TITAN 110 Operation & Maintenance Manual page 65

Operations
To remove the shield
a) Raise the safety shield.
b) Pull on the locator pin on the right from the
front operating position.
c) Lift the table up and out toward the right side
of the laminator.
Page 5 - 8
Titan 110/ 165 Operation and Maintenance Manual
To replace the shield
a) Position the safety shield tab on the left with
the shield positioning hole on the laminator.
b) Pull on the locator pin on the right from the
front operating position.
c) Lower the safety shield to its fully closed
position.
© GBC Films Group November 2000