Section 6 Applications; Pressure Sensitive - GBC TITAN 110 Operation & Maintenance Manual

Titan 110/ 165 Operation and Maintenance Manual

Section 6 Applications

The Titan 110/ 165 can accommodate Poly-in or
Poly-out films. Poly-out means the adhesive is on the
outside of the roll. Each film requires a slightly different
loading procedure. Refer to Web diagrams at the end of
this section.
The shiny side of clear film must contact the heating
components with the dull sides ( adhesive side ) facing
out. Use caution when loading matte or delustered film
since both sides appear dull.
The top and bottom rolls of laminating film must
be of the same width and be present simultaneously.
Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
The procedures and parameters described
in this section are reference points only. Parameters
will vary with regards to laminate thickness, laminate
widths, laminate types, print types, ink or toner types,
environment conditions and operator experience.
© GBC Films Group November 2000
WARNING

6.1 Pressure Sensitive

Follow the procedure below to web the Titan 110/
165 for pressure sensitive laminate and pressure sensitive
mount adhesive.
Materials need
• 1 roll of pressure sensitive laminate
( Same width as mount adhesive )
• 1 roll of pressure sensitive mount adhesive
( Same width as roll of laminate )
• Enclosed blade
( i.e. Zippy™ knife )
• Leader board
( approximately 24 in. in length ( 61 cm ) )
• Images
( i.e. Inkjet, piezo, electrostatic, offset )
INFORMATION
The Titan 110 is used for illustration
purposes. The procedure is the same
for the Titan 165.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the heated components.
This will prevent hours of cleaning!
Applications
CAUTION
Page 6 - 1