GBC TITAN 110 Operation & Maintenance Manual page 20

Titan 110/ 165 Operation and Maintenance Manual
INFORMATION
If is illuminated, the cooling fans
COOLING
are in the "on" position.
INFORMATION
Reverse speed is preset at 1 meter/ minute.
INFORMATION
When the set point value is higher than
actual temperature, " WAIT " is indicated
at the bottom of the display.
INFORMATION
When the input value for JOB is
changed, the parameters stored within
that number are displayed.
© GBC Films Group November 2000
INFORMATION
When an EMERGENCY STOP is engaged,
all motion stops. The nip will not change
from the operating setting.
INFORMATION
When the E-STOP is disengaged, the
rollers will begin turning. By pressing
stop first, The rollers will not turn
until RUN is pressed
INFORMATION
The Temperature control panel settings
are not affected when an E-STOP
has been pushed.
WARNING
Caution should always be exercised
when using the laminator with
the safety shields removed.
You can be seriously HURT or INJURED!
Safety
Page 1 - 9