Feed Table - GBC TITAN 110 Operation & Maintenance Manual

Operations

5.5 Feed table

The feed table is designed to be removable
allowing for quick and easy film webbing. The
laminator will only operate with the feed table in proper
position.
Caution should always be exercised
when using the laminator with
the safety shields removed.
You can be seriously HURT or INJURED!
At no time should you attempt to over ride
any of the safety latches on the laminator.
INFORMATION
All E-STOPS must be unlatched, safety
shield fully closed and feed table properly
installed before operating.
Page 5 - 10
WARNING
DANGER
Titan 110/ 165 Operation and Maintenance Manual
To remove the feed table
a) Raise the safety shield and remove the
pressure plate.
b) Pull the feed table safety pin located on the
left side from the front operating position.
c) Lift the rear of the feed table up and pull the
feed table out away from the laminator.
© GBC Films Group November 2000