GBC TITAN 110 Operation & Maintenance Manual page 70

Titan 110/ 165 Operation and Maintenance Manual
g) If using the 2 1/4 in. ( 5.7 cm ) adapters,
insert one adapter into one end of the roll of
film.
h) Slide the unwind shaft into the roll of film
then the other core adapter.
i) Insert the brake assembly side of the unwind
shaft in first. ( Core grippers are used for
illustration purpose only )
© GBC Films Group November 2000
j) Set the rounded end of the unwind shaft into
the upper unwind saddle.
k) Repeat steps " a " through " j " for the lower
unwind shaft.
CAUTION
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the heated components.
This will prevent hours of cleaning!
INFORMATION
For core grippers, turning the roll film in
the same direction as the gripper tabs while
sliding makes loading the film onto
the unwind shaft easier.
Operations
Page 5 - 13