GBC TITAN 110 Operation & Maintenance Manual page 18

Titan 110/ 165 Operation and Maintenance Manual
At no time should you attempt to over ride
any of the safety latches on the laminator.
INFORMATION
The laminator will operate only when
all safety latches are in the fully
latched position.
INFORMATION
Locator pins on the pressure plate are
not associated with an interlock switch.
The laminator can operate without
the pressure plate installed.
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
© GBC Films Group November 2000
DANGER
WARNING
INFORMATION
When any command is pressed on the
control panel, an audible "beep" will
be heard for each increment of
change or each press.
INFORMATION
Top and bottom set points are
intentionally left at 320
o
(160 C) for now.
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
CAUTION
Never leave the rollers in the down position
without rolling. Prolonged contact in one
area can form flat spots on the rollers.
Safety
o
F
Page 1 - 7