GBC TITAN 110 Operation & Maintenance Manual page 69

Operations
b) Pull the upper unwind shaft out from the
upper unwind shaft support.
Extreme caution should always be exercised
working around the 3 inch core grippers,
the gripper tabs can cut you!
c) If using the 2 1/4 in. ( 5.7 cm ) core adapters,
go to step " g ". If using the 3 in. ( 7.6 cm )
core grippers proceed with the next step.
Page 5 - 12
WARNING
1
2 / in c h
4
( 5 .7 c m )
a d a p te rs
3 in c h
( 7 .6 c m )
g rip p p e rs
Titan 110/ 165 Operation and Maintenance Manual
d) Ensure the gripper teeth are facing the
proper direction for Poly-in or Poly-out
film.Use the correct combonation to suit
your film
e) Use a 4 mm allen wrench to secure the core
gripper to the shaft so the grippers fall close
to the end of the roll of film.
f) Slide the unwind shaft into the roll of
laminate. Proceed with step " i ".
© GBC Films Group November 2000
( 1 ) Upper
Poly - in
( 2 ) Lower
Poly - out
( 2 ) Upper
Poly - out
( 1 ) Lower
Poly - in