Display Panel - HP EliteOne G5 Maintenance & Service Manual

Display panel

Spare parts for both touch and non-touch display are available as a raw panel.
IMPORTANT:
any old parts. Return all old parts to HP for warranty processing.
IMPORTANT:
can result in panel failure.
IMPORTANT:
loss of touch functionality. Go to
To remove the display panel:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the M.2 solid-state drive from above the right speaker (see
6. Remove the power button board and fingerprint sensor board (see
boards on page
7. Remove the audio board (see
8. Remove the rear I/O cover (see
9. Remove the 12 Phillips screws (1)-(12) that secure the main frame to the display panel.
10. Lift the left side of the frame (1).
11. Disconnect the display ribbon cable, and then route the cable through the hole in the frame (2).
60 Chapter 4 Removal and replacement procedures
Install the new display panel together with all other parts in the replacement kit. Do not reuse
Use the exact cable that shipped with the replacement panel. Failure to use the correct cable
You must install the latest touch drivers. Failure to install the latest drivers could result in a
www.hp.com/support
Removing the rear port cover on page
Stands on page
Access panel on page
35).
Audio board on page
Rear I/O cover on page
to install the latest drivers.
Preparation for disassembly on page
24).
25).
58).
47).
23).
23).
Heat sink on page 41).
Power button and fingerprint sensor