Display Panel - HP EliteOne 800 G3 Maintenance & Service Manual

Display panel

IMPORTANT:
any old parts. Return all old parts to HP for warranty processing.
CAUTION:
the correct cable may result in panel failure.
IMPORTANT:
loss of touch functionality. Go to
To remove the display panel:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the heat sink (see
6. Remove the webcam plastic cover (see
7. Remove the power button board and disconnect the cable from the fingerprint reader board (see
button and fingerprint reader boards on page
8. Disconnect the audio board cable from the system board (see
9. Remove the VESA bracket/Fan assembly (see
10. Remove the rear I/O cover (see
11. Remove the I/O bracket (see
12. Remove the 11 Phillips screws (1) that secure the main frame to the display panel.
56 Chapter 4 Removal and Replacement Procedures
Install the new display panel together with all other parts in the replacement kit. Do not reuse
it is very important to use the exact cable that shipped with the replacement panel. Failure to use
You must install the latest touch drivers. Failure to install the latest drivers could result in a
www.hp.com/support
Stands on page
Access panel on page
Heat sink on page
Rear I/O cover on page
I/O bracket on page
to install the latest drivers.
Preparing to disassemble the computer on page
Removing the rear port cover on page
20).
21).
35).
Webcam module on page
33).
VESA mounting bracket/fan assembly on page
47).
48).
19).
40).
Audio board on page 54).
19).
Power
43).