System Board Shield - HP 100B Maintenance & Serice Manual

System Board Shield

The system board shield sits above the system board. It is secured with five screws. You must
disconnect several cables that route to the system board to remove the shield.
Figure 6-47
To remove the system board shield:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. Disconnect the following cables from the system board:
●
WLAN cable
●
Inverter cable
●
Power button board cable
●
Webcam cable
●
Fan cable
●
Speaker cables
System board location
26).
Rear Cover on page
Preparing to Disassemble the Computer
27).
System Board Shield 63