System Board Shield - HP Compaq 6000 Pro Maintenance & Service Manual

10. Remove two screws that secure each speaker to the computer.
NOTE:
Figure 7-50
11. Remove the tape that secures the speaker wires to the computer.
12. Disconnect the speaker cable from the system board connector.
NOTE:
system board.
To install the speakers, reverse the removal procedures.

System Board Shield

The system board shield sits above the system board. It is secured with seven screws.
To remove the system board shield:
1. Prepare the computer for disassembly (see
2. Remove the small rear cover (see
3. Remove the port cover (see
4. Remove the stand (see
5. Remove the drive cover (see
6. Remove the memory cover (see
7. Remove the upper rear panel (see
8. Remove the I/O panel (see
9. Remove the outer/left panel (see
10. Remove the small fan (see
11. Remove the fan (see
92 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Make note of grounding wire placement for proper installation later.
Removing the speakers
The speakers can be disconnected from each other. The right speaker connects to the
Port Cover on page
Stand on page
Optical Drive on page
Memory on page
Rear I/O Cover on page
Small Fan on page
Fan on page
Preparing to Disassemble the Computer on page
Small Rear Cover on page
45).
46).
47).
53).
Upper Rear Panel on page
67).
Outer/Left Rear Panel on page
61).
89).
44).
55).
75).
43).