Amp Board Shield; System Board Shield - HP TouchSmart 9100 Maintenance And Service Manual

Amp board shield

1. Prepare the computer for disassembly (see
on page
2. Place the computer face down on a soft, flat surface.
3. Remove the hard drive/memory cover (see
4. Remove the stand (see
5. Remove the I/O cover (see
6. Remove the feet (see
7. Remove the back cover (see
8. Remove the amp board shield by removing the two screws (1), rotating the top outward and then
lifting the shield off the computer (2).
To install the amp board shield, reverse the removal procedures.

System board shield

1. Prepare the computer for disassembly (see
on page
2. Place the computer face down on a soft, flat surface.
3. Remove the hard drive/memory cover (see
28 Chapter 4 Removal and Replacement Procedures
12).
Stand on page
I/O cover on page
Feet on page
Back cover on page
12).
Preparing to disassemble the HP TouchSmart PC
Hard drive/memory cover on page
17).
15).
16).
22).
Preparing to disassemble the HP TouchSmart PC
Hard drive/memory cover on page
14).
14).