Oki MC873dn Maintenance Manual page 55

Oki Data CONFIDENTIAL
Panel display Cause
Inspection is Controller unit
required. cannot detect
056:Error the hard disk
Power OFF/ON Detect the time
057:Error out between the
Controller unit
and scanner unit
01 : No ACK for
read beginning
command
02 : No ACK
for read cancel
command
03 : No ACK
for SIP cancel
command
Power OFF/ON Detect the error
058:Error at scanner
control section
01 : SIP internal
error
02 : S ｃａ
ｎ Model internal
error
03 : SPB internal
error
Power OFF/ON Detect the
059:Error communication
error between
the Controller
unit and scanner
unit
Inspection is Detect the
required. communication Does this error recur?
067:Error error with the
Sleep Mode
interface
supervisor
program.
Inspection is Malfunction of
required. the NIC chip was Does this error recur?
069:Error detected.
Power OFF/ON A PSE firmware
070:Error error was
detected.
45850101TH Rev.1
Check details Result Solution
Power off the MFP and attach
the hard disk and power on
the MFP.
Record the figures on the
lower right side of the LCD,
and cycle the power.
Record the figures on the
lower right side of the LCD,
and cycle the power.
Record the figures on the
LCD, and close the error
display.
Cycle the power.
Yes Replace the CU/PU board.
Cycle the power.
Yes Replace the CU/PU board.
If display the address on the
LCD, record the figures and
close the error display and
cycle the power.
Panel display Cause Check details
Power OFF/ON I/F error between
072:Error CU and PU
Power OFF/ON Detect the Video
073:Error c/ circuit over run.
xxxxxxxx
Power OFF/ON Video error.
075:Error c/ An error was
xxxxxxxx detected in
expanding image
data.
Power OFF/ON VIC Illegal
077:Error Decomp Error Does this error recur?
Inspection is Communication
required. Error with Does this error recur?
078:Error Operator Panel
Unit
Power OFF/ON Failed to access
080:Error to the parameter Does this error recur?
storage
Inspection is Parameter
required. matching check
081:Error error
Inspection is Detect the error
required. at stapler unit.
090:Error
Inspection is An engine
required. EEPROM read/
104:Error write error was
detected at
power on
Inspection is Not detect the
required. EEPROM at
105:Error power on
Inspection is Detect the error
required. at engine control
106:Error logic
Inspection is A duplex unit for Is a duplex unit provided
required. another model for this model installed?
111:Error was detected
Inspection is A Tray2 for Is a Tray2 provided for
required. another model this model installed?
112:Error was detected.
Inspection is A Tray3 for Is a Tray3 provided for
required. another model this model installed?
113:Error was detected.
2. TROUBLESHOOTING PROCEDURES
Result Solution
Record the figures on the
lower right side of the LCD,
and cycle the power.
Record the figures on the
lower right side of the LCD,
and cycle the power.
Cycle the power.
Yes Replace the CU/PU board.
Cycle the power.
Yes Replace the CU/PU board.
Cycle the power.
Yes Replace the CU/PU board.
Format the EEPROM , Flash
and need the initialize.
Replace the stapler unit or
CU/PU Board,and cycle the
power.
Cycle the power.
No Install a correct duplex unit.
No Install a correct Tray2.
No Install a correct Tray3.
2-30