Maintenance Menu - Oki MC873dn Maintenance Manual

Oki Data CONFIDENTIAL

3.1 Maintenance Menu

Service Menu
When the equipment is in standby mode, access the password entry screen by pressing [Setting] → [#] → [0] → [1] → [0] → [3] → [*].
Note! The initial Password is set to "000000" (six zeros).
Item1 Item2 Item3
Password
System OKIUSER
Maintenance
*MPS mode:
MPS. Not
shown during
maintenance.
Format HDD
Format Flash
Memory
Reset Admin
Password
All Reset
*MPS mode:
MPS. Not
shown during
maintenance
45850101TH Rev.1
Item4 Item5 Value
************
ODA
OEL
APS
JP1
JPOEM1
OEMA
OEML
Default Default Default
value value value
ODA OEL JP
Enter the password for accessing the maintenance menu.
6 to 12 characters (numerals and lower-case alphabetic characters)
may be entered.
Set the destination.
JPOEM1 : OEM for Japan
OEMA : OEM for overseas, with A4 as default size
OEML : OEM for overseas, with Letter as default size
Device reboots automatically after exiting the menu.
Displayed under the following conditions:
However, operation when JP1/JPOEM/OEMA/OEML is chosen is not
guaranteed.
The display condition of the menu is following two.
① "System Maintenance" - "OKIUSER" is other than JPOEM1, OEMA
or OEML
② "Manufacturer" is "OKI DATA CORP".
Formats HDD.
Formats flash memory.
When this command is executed, the menu is exited and formatting of
the resident(onboard) flash device begins.
Use of this command is strictly prohibited (contact design before use)
Returns the administrator password to the factory default value.
Returns the content of EEPROM and Flash memory and HDD to their
factory default values.
When this command is executed, the following confirmation message
is displayed:
"This change will reboot the device automatically. Proceed?"
When "No" has been selected, the system returns to the previous
menu. When "Yes" has been selected, the menu is exited immediately
and then, after rebooting, reset processing begins.
See the "format scope" sheet for the scope of formatting.
3. MAINTENANCE MENUS
Notes
3-2