Xerox Versant 2100 Press System Administration Manual page 77

Offset Stacking (Right Top Tray, Stacker, Stacker Cart)
Select the default offset stacking option for the finisher tray:
• Off: If this option is selected, the finishing tray will not offset any output.
• Offset per set: If this option is selected, the finishing tray will offset each set of a
print job. This option also offsets each job.
• Offset per job: If this option is selected, all the sets of a job are delivered on one
stack to the output area. When the next job starts, that job is offset from the previous
job in the tray. This option does not offset each set of a job.
Unload High Capacity Stacker
Indicate when to unload the stacker; when current set completes or to stop immediately
and unload.
Default Print Paper Size
Set the default paper size (A4 or 8.5 × 11 in.) on which to print reports and/or lists.
Paper Size Settings
Specify the size of paper to be automatically detected when you use standard sizes
for a document or the press is set to detect sizes of a document. Select one of the
following options:
• A/B Series (8 × 13 in.)
• A/B Series
• A/B Series (8K/16K)
• A/B Series (8 × 13 in./8 × 14 in.)
• Inch Series
Millimeters/Inches
Select the unit of measurement that will be displayed on the screen; select either
Millimeters or Inches.
Data Encryption
If you want the recorded data on the hard disk encrypted, select On as the default
setting for this feature. By switching on the data encryption, all data written to the
hard disk is automatically encrypted. Encryption prevents unauthorized access to the
stored data. When encryption is on, an encryption key must be set.
Xerox ® Versant 2100 Press
System Administration Guide
Common Service Settings
6-21