Billing Impression Mode; Using The Fuser Nvm Read/Write Setting - Xerox Versant 2100 Press System Administration Manual

6. Push the paper guides to their minimum width.
7. Select Minimum Position and press the Start button on the Control Panel.
If the sensor output value is within the specified range, OK displays in the Result box.
If the value is out of the specified range, NG displays. Check the guide position and
retry.
8. Push the paper guides to their maximum width.
9. Select Maximum Position and press the Start button on the Control Panel.
If the sensor output value is within the specified range, OK displays in the Result box.
If the value is out of the specified range, NG displays. Check the guide position and
retry.

Billing Impression Mode

The Billing Impression Mode defines how the press tracks impressions made on large
sheets, such as A3 or tabloid size stock. There are two modes:
• A3 Impression Mode counts all impressions equally
• A4 Impression Mode counts large impressions as their A4 equivalent
A Xerox Sales Representative can confirm the Billing Impression Mode used by your
press.

Using the Fuser NVM Read/Write Setting

When the fuser is replaced and installed with a different fuser type (width range
capability), the System Administrator can update and set the NVM fuser width range
for that fuser at the press touch screen, if the settings in
This NVM fuser width setting enables those width papers to print. The system will then
confirm the correct paper widths are being used to print.
1. Logon as Administrator.
2. Select the Tools button on the Control Panel.
3. From the Tools screen, select System Settings > Common Service Settings.
4. Under Features, scroll to and select Maintenance.
5. From the Maintenance screen, select NVM Read/Write.
6. Referring to the table below, type in the corresponding 6-digit Chain Link Number
associated with the fuser range to be tracked. The current NVM value displays.
7. Select the Confirm/Change button.
8. Using the keyboard, enter the minimum and maximum paper width range of the
fuser in millimeters (such as 200mm to 400mm). To set up custom width sizes, add
5 mm to the upper limit and subtract 5 mm to the lower limit.
Xerox ® Versant 2100 Press
System Administration Guide
Common Service Settings
Table 1 are not acceptable.
6-17