Maintenance - Xerox Versant 2100 Press System Administration Manual

5. Select Reports.
6. Select the feature to be set or changed.
7. Select Change Settings and the desired setting for the option.
8. Select Save.
The Reports screen displays.
9. Select another option to set or change and save those settings.
10. When completed, select Close.
The main Tools screen displays.
11. Exit the administrator mode.

Maintenance

Use this feature to further customize the press settings for the following options:
Quick Home Setup
Use this option to quickly define network settings and create a self-signed digital
certificate for the press.
Initialize Hard Disk
Use this option to initialize the press hard disk. This erases any current data on the
hard disk.
Software Options
This feature is for service representatives only. It may be used when installing optional
software applications. For more information, contact the Xerox Customer Support
Center.
USB Key
This feature is not currently available. When enabled, it provides the capability to load
software kit options using a USB device connected to the system instead of a pin code.
Power On Self Test
Select whether or not to perform a self test when the press is switched on/started. If
any abnormal conditions are found, such as intentional program modification, the
press stops and records the information in the audit log. If the press does not start,
contact the Xerox Customer Support Center.
NVM Read Write
The Xerox Service Representative uses this feature to change certain system settings.
It also may be used by the system administrator for updating the fuser width NVM
setting after it is replaced.
Xerox ® Versant 2100 Press
System Administration Guide
Common Service Settings
6-15