7.4.3 REMOVING THE ECCENTRIC CAM
Carefully read 1.3.9 (PRECAUTIONS AND GENERAL
INFORMATION).
Remove
the
swinging
(REMOVING THE FINAL DRIVE ASSEMBLY).
Loosen the two screws (1).
Tightening torque for nuts (1): 25.8 ftlb (35 Nm).
Remove the snap ring (2).
Slide the eccentric cam out from the left side.
NOTE
Remove the individual components if necessary.
7.4.4 REMOVING THE SPROCKET
Place the vehicle on the center stand.
Loosen
the
drive
(ADJUSTING THE DRIVE CHAIN).
Unscrew and remove the six nuts (1).
NOTE
When reassembling, insert all nuts (1) by hand
and cross-tighten to torque.
Tightening torque for nuts (1): 18.4 ftlb (25 Nm).
Slide the sprocket out from the left side of the vehicle.
7
- 64 -
00
arm
pivot,
see 7.4.1
chain
tension,
see 2.35.3
2
1
1
RST mille
USA
1
1
1
Release 00/2002 - 03