APRILIA RST FUTURA - 2001 Dealer Instructions

INSTRUCTIONS FOR THE DEALER
8
Loosen the left-hand terminal screws. Reset the
motor cycle by dry running the suspension two or three
times to line up the rods.
Secure the screws (5) and (8) in the left-hand and
right-hand terminals.
Screw (5 - 8) tightening torque: 16,22 ftlb (22 Nm).
CAUTION
The screws in the terminals are elastic: tighten one
then the other, then re-tighten the first.
aprilia part #8104327 - 04/01 - USA
RST Futura
5
9
Fit the left-hand brake gripper (9) securing the
screws (10).
Repeat for the right-hand brake gripper.
Screw (10) tightening torque: 36,87 ftlb (50 Nm).
Reset the brake grippers, pulling the brake lever on
the handlebar twice.
Pag. 4
INSTRUCTIONS FOR REMOVING
MOTORCYCLE FROM CRATE
SAFETY MESSAGES
The following warning messages are used on all the
instruction sheets to draw your attention to the situations
described below.
Safety warning symbol. When you see this
symbol on the motorcycle or instruction sheets,
beware of potential injury hazards.
Failure to observe the instructions following these
symbols may affect your safety, the safety of
others and that of the motor cycle!
Risk of serious injury or death.
Possible risk of slight injury or damage
10
to motor cycle.
DANGER
Risk of serious injury or death.
CAUTION
Possible risk of slight injury or damage to motor
cycle.
IMPORTANT
The word "IMPORTANT"is written before any important
information on the instruction sheet.
INSTRUCTIONS FOR THE DEALER
RST Futura
RST Futura
For the sake of safety, before starting the
vehicle, carry out a thorough preliminary check.
See the PRELIMINARY CHECK LIST IN THE
VEHICLE OPERATION AND MAINTENANCE
HANDBOOK.
Failure to carry out these checks may lead to
serious injury or damage to the vehicle.
Very little time is required, and the benefits in terms
of safety are enormous.
The components in this handbook are supplied
disassembled, and have to be fitted to the motor cycle.
These instruction sheets for dealers describe the
correct fitting procedures.
Read the instructions in the sheets to avoid
breakages or incorrect assembly.
Remove the bag containing the mirrors and other loose
parts (i.e. not fitted to the motor cycle body) from the
crate.
After removing the nailed-on supports and crosspieces
from the crate (used for transport purposes), push the
motor cycle off the bottom of the crate and position it
on the stand.
You can now proceed with the operations
described below.
Pag. 1
RST Futura