Reassembling The Rear Wheel - APRILIA RST mille Futura 2001 Service Manual

CHASSIS
7.3.2

REASSEMBLING THE REAR WHEEL

DANGER
Before reassembly, make sure the key (1) is present
and correctly positioned. Place it correctly if it has
fallen from its seat. Do not forget to remount it.
Turn the drive shaft so that the key (1) is at the top.
Mount the wheel (2) on the drive shaft, making sure
that the three drive pins (3) are correctly inserted in the
wheel slots.
Engage first gear to keep the wheel from turning.
Make sure the key (1) is present on the drive shaft
seat.
Place the centering bushing (4) correctly, mating the
slot (5) with the key (1).
Spread a light coating of grease lubricant on the thread
of the wheel fastening screw (6).
Screw in the wheel fastening screw (6) by hand.
Insert the bushing (8) in the screw hole (7).
Insert the torque wrench into the hexagonal slot of the
bushing (8).
DANGER
Make sure that the wheel fastening screw (6) is
tightened to the prescribed torque.
Tightening torque for wheel fastening screw (6):
125.3 ftlb (170 Nm).
Tighten the wheel fastening screw (6).
Insert the screw locking nut (9) into the screw hole (7),
seeking the correct position for complete insertion.
7
- 58 -
00
3
1
3
2
5
8
6
7
RST mille
USA
3
4
9
Release 00/2002 - 03