Removing The Fuel Intake Pump - APRILIA RST mille Futura 2001 Service Manual

RST mille
USA

4.6 REMOVING THE FUEL INTAKE PUMP

Remove the complete fuel intake pump unit, see 4.3
(COMPLETELY REMOVING THE FUEL INTAKE
PUMP UNIT).
Disconnect the electrical connector (1).
WARNING
When reassembling,
connector (1) is fitted properly.
NOTE
Use the special click clamp installation pliers
(code 0277295); during reassembly, replace each clamp
with a new one of the same kind.
Release the click clamp (2).
Slide the fuel hose (4) from the pump (3).
Unscrew and remove the three bolts (5).
WARNING
When performing the operations listed below, take
care not to stretch or twist the electrical wires.
Remove the snap ring (6) from the filter element (7).
WARNING
When reassembling, replace the snap ring (6) with a
new one of the same kind.
Remove the filter element (7).
WARNING
If the filter element (7) show traces of sediment, clean
it using compressed air.
Use a screwdriver to help you slide it out from the side
opposite the fuel pump (3).
Release 00/2002 - 03
make sure the electrical
1
3
5
5
7
FUEL SYSTEM
4
2 2
6
3
4
- 7 -
00