APRILIA RST mille Futura 2001 Service Manual page 279

RST mille
USA
7.4.1 REMOVING THE FINAL DRIVE ASSEMBLY
Carefully read 1.3.9 (PRECAUTIONS AND GENERAL
INFORMATION).
Remove the wheel, see 7.3.1 (REMOVING THE
COMPLETE WHEEL).
Remove the lower chain shoe, see 7.1.57 (REMOVING
THE DRIVE CHAIN SHOE).
Loosen the drive
(ADJUSTING THE DRIVE CHAIN).
NOTE
To remove the sprocket
(REMOVING THE SPROCKET).
Unscrew and remove the three safety screws (1-2).
Tightening torque for safety screws (1-2): 110.6
ftlb (150 Nm).
WARNING
When reassembling make sure that the safety screw
(1) (the longer one) is all the way down in one of the
three holes in the wheel fastening screw (3).
Insert the bushing (5) supplied with the tool kit into the
screw hole (4).
Insert the torque wrench into the hexagonal slot of the
bushing (5).
Unscrew and remove the axle fastening screw (3);
retrieve the Belleville washer (6) if it has fallen out.
Tightening torque for axle screw (3): 110.6 ftlb
(150 Nm).
Remove the hub (7) complete with sprocket (8) from
the axle (12).
Release 00/2002 - 03
chain tension, see 2.35.3
(8), see 7.4.4
1
3
2
5
6
3
8
7
4
7
- 61 -
00