APRILIA RST mille Futura 2001 Service Manual page 280

Retrieve the O-ring (9).
Unscrew and remove the six screws (10).
NOTE
To unscrew the screws (10), we recommend
using an impact wrench, which delivers the sharp blow
needed to release the screws from the LOCTITE
Unscrew and remove the six brake disc screws (10).
WARNING
When reassembling, apply LOCTITE
thread of the brake disc screws.
NOTE
When reassembling, insert all screws by hand
and cross-tighten.
Tightening torque for brake disc screws (10):
22.1 ftlb (30 Nm).
Lower the brake disc (11).
Slide the axle (12), complete with brake disc (10), out
from the right side.
Remove the snap ring (13).
Remove the snap ring (14).
WARNING
When reassembling the snap rings (13-14), make
sure that you hear the typical "click" indicating that
the ring is correctly fastened.
Remove the brake caliper support (15) complete with
brake caliper, keeping them attached to the brake line.
If necessary:
Remove the eccentric cam, see 7.4.3 (REMOVING
THE ECCENTRIC CAM).
7
- 62 -
00
®
243.
® 243 to the
14
9
10
10
13
15
RST mille
USA
10
12
Release 00/2002 - 03