APRILIA RST mille Futura 2001 Service Manual page 235

RST mille
USA
Loosen the lock nut (3).
Release the throttle cable adjuster (4) from its coupling.
Disconnect the throttle cable.
Repeat the last three steps for the other throttle cable
as well.
WARNING
When reassembling make sure that the two throttle
cable adjusters are properly fastened to their
respective couplings; check and, where necessary,
restore the correct
(ADJUSTING THE THROTTLE CONTROL).
Move the winch (5) and disconnect the two throttle
cables.
Slide off the throttle grip (6).
7.1.15 REMOVING THE FRONT BRAKE CONTROL
Carefully read 1.3.9 (PRECAUTIONS AND GENERAL
INFORMATION).
Place the vehicle on the stand.
Set the ignition switch to "
Unscrew and remove the two screws (2) fastening the
front brake control (3).
Tightening torque for screw (2): 7.3 ftlb (10 Nm).
Remove the front brake lever clamp (1) and move the
front brake control (3), which remains attached via the
brake line.
NOTE
When reassembling the brake lever clamp (1)
must be placed with the arrow, engraved on the top,
facing upward.
Should you need to completely remove the front brake
control (3):
Carry out the first three steps described in the chapter
2.21 (CHANGING THE FRONT BRAKE FLUID).
When all the fluid has drained out, unscrew and
remove the screw (4) and retrieve the two seals.
Tightening torque for screw (4): 1.4 ftlb (2 Nm).
Release 00/2002 - 03
clearance, see 2.11.3
".
4
5
6
4
1
2
CHASSIS
3
3
7
- 17 -
00