APRILIA RST mille Futura 2001 Service Manual page 236

CHASSIS
WARNING
When reassembling, replace the two seals with two
new washers of the same type.
Use a small blade screwdriver to pry out and remove
the front brake switch (5) from the two slots on the front
brake control lever (3).
Remove the front brake control (3).
7.1.16 REMOVING ELECTRICAL CONTROLS ON THE
RIGHT HANDLEBAR
Carefully read 1.3.9 (PRECAUTIONS AND GENERAL
INFORMATION).
Place the vehicle on the stand.
Set the ignition switch to "
Remove the front fairing, see 7.1.20 (REMOVING THE
FRONT FAIRING).
Disconnect the electrical connector (1) of the right
dimmer switch.
WARNING
When reassembling, make sure the connector (1) is
fitted properly.
Disconnect the connector (2).
WARNING
When reassembling, make sure the connector (2) is
fitted properly.
Unscrew and remove the two screws (3-4) fastening
the two halves of the controls (5-6) from the bottom.
NOTE
When reassembling, the shorter screw (3) must
be placed in front.
Separate and remove the two half-cylinders (5-6).
WARNING
When reassembling, first position the lower portion
of the control (5), making sure the positioning pin is
inserted in the corresponding hole on the handlebar.
7
- 18 -
00
".
3
5
1
6
4
5
5
RST mille
USA
2
3
Release 00/2002 - 03