Table of Contents
Advertisement
15
Configuring Camera Settings Using a Browser
To configure Email Alarms:
1. Under Email/FTP Trigger, select one of the following alarm triggers:
• Motion: Use Video motion detection to trigger email alarms. Video motion detection
looks for movement in the image to determine if there is motion. This means that
there may be false alarms caused by changes in lighting, trees moving in the wind,
etc.
• Schedule: Send email alarms based on the settings configured under Schedule.
see 15.4.4 Scheduling (Configuring Recording and Alarm Schedules), page 134.
• Disable: Disable email alarms.
2. If you have selected Motion, under Motion Sensitivity, select the motion detection
sensitivity between 1 (High) and 10 (Low). If Motion Detection Sensitivity is set to 1,
motion detection will be triggered if a moving object is larger than 1% of the video area.
If it is set to 10, a moving object must be larger than 10% of the video area to trigger
motion detection.
3. Under Trigger Interval, enter the minimum time (in seconds) the camera will wait in
between email alarms. If this Interval is set too low, you may receive a lot of messages.
4. Under Email Recipient, enter up to 3 email addresses that will receive email alarms.
5. Click Save & Apply to save email alarm settings.
NOTE
If you want to use a custom SMTP server to send Email messages, click Advanced, enter your SMTP
server information, and click Save & Apply.
15.4.2 Speaker Alarm (Configuring Audio Alarms)
A siren can be set up to go off when the camera detects motion. This is helpful if you want
to scare off intruders.
#LX400072; r.28402/28402; en-US
132
Advertisement
Table of Contents
