Configuring The Camera; Opening Digiconsole - Lorex LNE1001 Instruction Manual

CONFIGURING THE CAMERA

With the camera setup and connected, you can now set up local viewing, remote viewing, and
wireless connectivity.
: Before starting the installation, please ensure your computer is connected to the
ATTENTION
same local network as the camera and has access to the Internet.
NOTE: It is recommended to install the camera when your computer is wired to the local network. If you
are using the wireless connection on your computer, please connect your computer to your wireless
router using an Ethernet cable (not included).
NOTE: The following refers to an installation on Windows Vista. Some steps may differ in Windows XP.

Opening DigiConsole

Use DigiConsole to setup your camera.
NOTE: Prior to using DigiConsole, visit www.lorexcctv.com and check for software and firmware updates.
Please refer to the DigiConsole & DigiViewer Software Manual for more information on upgrading
firmware.
To open DigiConsole:
1. Insert the included DigiConsole software CD into your CD/DVD-ROM drive. DigiConsole
automatically launches.
Figure 4.0 DigiConsole main window
2. If a security pop-up window appears, click Unblock and Continue to allow DigiConsole access
to the Internet.
NOTE: If Autorun fails to start, go to Computer (My Computer for Windows XP users) and double-click
the CD-drive to run the application. Follow step 2.
NOTE: You do not need to install DigiConsole to view live video from the camera. However, if you wish to
record and playback video, you must install DigiConsole to your computer. Please refer to the DigiConsole
& DigiViewer Software Manual for more information on installing DigiConsole.
12