Wifi Security (Configuring Wifi Settings) - Lorex LNC254 series User Manual

15 Configuring Camera Settings Using a Browser
To configure the camera to use DHCP or fixed IP:
1. Select one of the following:
• Obtain an IP address automatically (recommended): Use DHCP and allow the
camera to obtain an IP address from the router automatically.
• Use the following IP address: Use a fixed IP address and manually enter the IP
address information.
2. If you selected Use the following IP address, configure the following:
• IP address: Enter the IP address the camera will use. Make sure it is available on
your network.
• Subnet mask: Enter the Subnet Mask.
• Default Gateway: Enter the Default Gateway address.
• Obtain DNS server address automatically: Select to have the camera automati-
cally select a DNS server.
• Use the following DNS server address: Select and then manually enter DNS
server information.
3. Click Save & Apply.

15.2.2 WiFi Security (Configuring WiFi settings)

Configure the camera to connect to a WiFi network and configure WiFi settings.
To configure WiFi Settings:
NOTE
For instructions on connecting your camera to a WiFi network, see 8.2 PC WiFi Setup, page 25 or 9.2
Mac WiFi Setup, page 30.
#LX400072; r.28402/28402; en-US
127