Setting Up The M2007 (Usb) Scanner; Bus Power - Symbol Cyclone M2000 Series Product Reference Manual

Cyclone
9. Verify that the scanner is successfully reading bar codes and transmitting their
content to the host.
See Troubleshooting

Setting Up the M2007 (USB) Scanner

The M2007 connects through the USB and operates with USB capable hosts including:
• Desktop PCs and Notebooks
• Apple™ iMac, G4, iBooks
• IBM SurePOS terminals
• Network computers.
The following operating systems support the M2007 through USB:
• Windows 98, 2000, ME, NT 5.0
• MacOS 8.0 and above
• 4690 OS v2.3 and above.
Ask your vendor if your host supports USB, and if your version of the operating system
supports USB. For more information on USB technology, hosts, and peripheral devices,
visit www.usb.org.

Bus Power

An additional power supply is not required to operate the M2007 since the USB host or self-
powered hub provides enough power.
To set up your M2007:
1. Connect the cable to the scanner.
2. Plug the series A connector in the USB host or hub, or plug the power+ connector
in the IBM SurePOS terminal.
3. Select the USB device type. See
4. On first installation when using Windows, the software prompts you to select or
install the USB device driver. Follow the installation instructions on the screen. The
scanner powers up during this installation.
5. If you are not using a North American keyboard, scan the appropriate country bar
code under
If you are having any problems with your system, see
1-4
TM
M2000 Series Product Reference Guide
on page 2-11 if you are having problems after completing these steps.
Country Selection
USB Device Type
on page 3-109.
Troubleshooting
on page 3-107.
on page 2-11.