Setting Up the Digital Scanner
Standard Model
Installing the Interface Cable
Plug the interface cable modular connector into the cable interface port on the bottom of the scanner handle
1.
(see
Figure
1-3).
Gently tug the cable to ensure the connector is secure.
2.
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
3.
connections).
Clip
Installing the Cable
Figure 1-3
NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
Connectors vary from those illustrated, but the steps to connect the digital scanner are the same.
Removing the Interface Cable
Using the tip of a screwdriver, depress the cable's modular connector clip.
1.
Removing the Cable
Figure 1-4
Carefully slide out the cable.
2.
Follow the steps for
3.
Cable interface port
Interface cable modular
connector
To host
Installing the Interface Cable
to connect a new cable.
Getting Started
1 - 3