Prefix/Suffix Values - Symbol Cyclone M2000 Series Product Reference Manual

Prefix/Suffix Values

A prefix and/or one or two suffixes may be appended to scan data for use in data editing.
These values are set by scanning a four digit number (i.e., four bar codes) that corresponds
to key codes for various terminals. See the
Note: If a keyboard interface is being used, refer to the Synapse "Smart
Cable" Interface Guide for keystroke values to be used as prefix/
suffix values.
To set a PREFIX/SUFFIX value:
1. Scan the option bar code you wish to set.
2. Scan four Numeric Bar Codes
ASCII value or keystroke value you wish to assign. The ENTER key is the default
for all options.
3. If you make an error, or wish to change your selection, scan the
on page 3-132.
Note: In order to use Prefix/Suffix values, the
Format
beginning on
Scan Suffix (Value 1)
Scan Prefix (Value 2)
must be set. See page
Table A-4 on page A-8
page 3-130
Scan Data Transmission
3-90.
Parameter Menus
for ASCII values.
which correspond to the
Cancel bar code
3-89