Set Lengths For Code 93 - Symbol Cyclone M2000 Series Product Reference Manual

Cyclone

Set Lengths for Code 93

Lengths for Code 93 may be set for any length, one or two discrete lengths, or lengths
within a specific range. The length of a code refers to the number of characters (i.e.,
human readable characters), including check digit(s) the code contains. See
on page A-8 for ASCII equivalents.
• One Discrete Length - This option allows you to decode only those codes
containing a selected length. For example, if you select Code 93 One Discrete
Length, then scan 1, 4, only Code 93 symbols containing 14 characters are
decoded.
• Two Discrete Lengths - This option allows you to decode only those codes
containing two selected lengths. For example, if you select Code 93 Two Discrete
Lengths, then scan 0, 2, 1, 4, only Code 93 symbols containing 2 or 14
characters are decoded.
• Length Within Range - This option allows you to decode a code type within
a specified range. For example, to decode Code 93 symbols containing
between 4 and 12 characters, first scan Code 93 Length Within Range. Then
scan 0, 4, 1 and 2 (single digit numbers must always be preceded by a leading
zero).
• Any Length - Scanning this option allows you to decode Code 93 symbols
containing any number of characters.
Numeric bar codes begin on
selection, scan the Cancel
3-62
TM
M2000 Series Product Reference Guide
page 3-130. If you make an error, or wish to change your
bar code on page 3-132.
Table A-4