Default Table - Symbol Cyclone M2000 Series Product Reference Manual

Default Table

Table 3-1 lists the defaults for all parameters, and the page number each parameter
appears on. If you wish to change any option, scan the appropriate bar code(s).
Set Default Parameter
Host Type
Scanning Options
Hand-Held Scan Pattern Mode
Hand-Held Scan Pattern Mode Selector
Counter-top Scan Pattern Mode
Raster Height
Raster Expansion Rate
Aiming Mode
Trigger Mode
Time-out Between Same Symbol
Time-out Between Different Symbols
Laser On Time
Time Delay to Low Power Mode
Beep After Good Decode
Beeper Volume
Beeper Tone
Transmit "No Decode" Message
Table 3-1. Default Table
Parameter
Parameter Menus
Default
All Defaults
See page 3-12
Smart Raster
Enable
Cyclone
15
11
Single Scan Line Raster
Level
0.6 sec
0.0 sec
5.0 sec
30 Minutes
Enable
High Volume
High Frequency
Disable
Page #
3-11
3-12
3-16
3-17
3-18
3-19
3-19
3-20
3-21
3-22
3-22
3-23
3-23
3-24
3-24
3-25
3-25
3-3