Programmable Raster Height And Raster Expansion Speed - Symbol Cyclone M2000 Series Product Reference Manual

Programmable Raster Height And Raster Expansion Speed

This parameter selects the laser pattern's height and rate of expansion, and is only used
when Programmable Raster or Always Raster is enabled. This parameter is intended for
very specific applications, and is usually not necessary.
Select the laser pattern's height and/or rate of expansion.
1. Scan the bar code for either Raster Height or Raster Expansion Speed below.
2. Scan two numeric bar codes beginning on
value. Valid values are between 01 and 15.
3. If you make an error, or wish to change your selection, scan Cancel on page 132.
Raster Height (Default 15)
Raster Expansion Speed (Default 11)
page 3-130 that represent a two-digit
Parameter Menus
3-19