Table of Contents
Advertisement
General Functions
If block dialling is switched off, the telephone switches to open-listening
mode as soon as you enter a call number and dial it.
Note:
An initiated automatic dialling is automatically terminated after
60 seconds if no further entries are made.
Block Dialling and Headset Operation
It is useful to activate the "block dialling" feature when using a headset (if you
have activated this via the MenuCard
number entered will only be dialled once you have pressed the headset
K
key
.
Once block dialling has been activated and the headset switched on, the
phone immediately switches over to headset operation and the call number is
dialled when you enter a number on the phone.
Information about block dialling and CTI applications
If you use CTI applications, you should switch off the "block dialling" function
on your system telephone. This applies for all CTI applications, except for the
application Forum CTI.
Automatic Dialling for a Different Terminal
You can use your system telephone for dialout for a different terminal (e.g. a
DECT headset). To do so, save a destination call number on your system tele-
phone (via the MenuCard
, please refer to page 123 also). The saved call number will be dialled
dialling
automatically when you press the headset key within 30 seconds. After 30
seconds, the dialout will be deactivated automatically.
This feature can be used for all devices for which the system administrator
has configured a device ID. This means that you can also save a dialout for
another user who, e. g. also has a system telephone.
For the System Administrator:
Device IDs are set up in the Configurator, Telephony: Extended: Device ID
menu. Authorisation for this feature is assigned in the User Manager: User
groups menu with the Dial for other phone setting.
4 Phone settings
, the menu entry
6 Connections
Telephoning
, see page 118). The call
:
2 Dial
0 Remote
51
Advertisement
Table of Contents
