Docking Board Shield - HP Sprout Maintenance & Service Manual

Docking board shield

The docking board shield is located under the inside cover. It secured with four Torx screws.
To remove the docking board shield:
1. Prepare the computer for disassembly (see
2. Remove the rear covers from the computer (see
on page
3. Separate the computer from the column (see
4. Remove the bottom cover (see
5. Remove the side and top cover (see
6. Remove the inside cover (see
7. Remove the four Phillips Torx screws (1) that secure the shield to the computer. Note the location
through which the power cable is routed (2).
ENWW
78).
Bottom cover on page
Inside cover on page
Preparing to disassemble the column on page
Removing the rear covers from the computer
Separating the computer from the column on page
83).
Side and top cover on page
87).
84).
Docking board shield
77).
80).
89