Table of Contents
Advertisement
Docking board
Description
Docking board
Before removing the docking board, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Remove the bottom cover (see
Remove the docking board:
1.
Disconnect the keyboard/base docking cables (1) from the docking board.
2.
Release the zero insertion force (ZIF) connector (2) to which the TouchPad board cable is attached,
and then disconnect the TouchPad board cable from the docking board.
3.
Release the ZIF connector (3) to which the keyboard cable is attached, and then disconnect the keyboard
cable from the docking board.
4.
Remove the two Phillips PM2.0×2.4 broadhead screws (4) that secure the docking board to
the keyboard/top cover.
5.
Remove the docking board (5).
Reverse this procedure to install the docking board.
46
Chapter 6 Keyboard/base removal and replacement procedures
Bottom cover on page
44).
Spare part number
841560-001
Advertisement
Table of Contents
