Display Assembly - HP Sprout Maintenance & Service Manual

Display assembly

To remove the display assembly:
1. Prepare the computer for disassembly (see
2. Remove the rear covers (see
3. Remove the hard drive (see
4. Separate the computer from the column (see
5. Remove the system board cover (see
6. Remove the system board (see
7. Disconnect the backlight cable from the display (at bottom left), and then remove the 14 Torx screws
that secure the display to the main system frame assembly.
NOTE:
into the frame.
CAUTION:
assembly. After removing the screws, be sure to separate the frame from the display only enough to
gain access to and disconnect this cable.
ENWW
Removing the rear covers from the computer on page
Hard drive on page
System board on page
The screws required to remove the display assembly are marked with an arrow that is stamped
A cable that is mounted on the frame is connected to the touch board on the display
Preparing to disassemble the computer on page
28).
Separating the computer from the column on page
System board cover on page
68).
26).
47).
Display assembly
25).
35).
73