Docking Board - HP Sprout Maintenance & Service Manual

Docking board

The docking board is secured with five Torx screws. Seven cables are connected to the top of the board and
four cables are connected to the bottom of the board.
To remove the docking board:
1. Prepare the computer for disassembly (see
2. Remove the rear covers from the computer (see
on page
3. Separate the computer from the column (see
4. Remove the bottom cover (see
5. Remove the side and top cover (see
6. Remove the inside cover (see
7. Remove the docking board shield (see
8. Disconnect the following cables:
(1): NFC Touchmat
(2): Lamp
(3): Projector
(4): Projector power
(5): Hi-res camera
(6): Main power
(7): HDMI
ENWW
78).
Bottom cover on page
Inside cover on page
Preparing to disassemble the column on page
Removing the rear covers from the computer
Separating the computer from the column on page
83).
Side and top cover on page
87).
Docking board shield on page
84).
89).
Docking board
77).
80).
91