Troubles For Which Error Messages Are Given On The Lcd; Errors Accompanied By Warnings - MIMAKI UJF-605C Operation Manual

Troubles for which error messages are given on the LCD

If something is wrong with the device, the buzzer sounds and a corresponding error mes-
sage is given on the LCD. Take an appropriate corrective measure in accordance with the
message.

Errors accompanied by warnings

Warning message
! UV LAMP
UV LAMP CHANGE
! UV LAMP
UV LEVEL CHK
<<LOC.>> NEAR END
COLOR :KCMYcmW
! INK END
COLOR :KCMYcmW
<<LOC.>> use LIMIT
COLOR :KCMYcmW
! INK CARTRIDGE
COLOR :KCMYcmW
! INK TANK
WASTE TANK FULL
!MEDIA HEIGHT
TABLE DOWN
! WRONG CARTRIDGE
COLOR :KCMYcmW
! REINSERT CART.
COLOR :KCMYcmW
Cause
Changing time for the UV lamp.
:ent
The UV lamp level has come to
the admeasurement time.
:ent
The amount of ink remaining in
the ink cartridge is insufficient.
The ink cartridge has run out of
ink.
The ink will expire soon or has
expired.
The ink cartridge is not attached
to the ink station.
Waste ink tank is full.
The device has detected that the
print heads and the media may
come into contact with each other
during the jog operation.
The loaded ink cartridge is
defective.
Ink near end was detected right
after the cartridge with much
remaining amount of ink has been
inserted.
- 6-4 -
Corrective measure
Contact your local distributer or to
call for service to change the UV
lamp.
Confirming UV lamp light level.
( P.5-23)
[REMOTE] key. However, it is
recommended to replace the ink
cartridge of which number is shown
on the LCD with a new one.
Replace the ink cartridge of which
color is shown on the LCD with a
new one.
[REMOTE] key. However, it is
recommended to replace the ink of
which number is shown on the
LCD with a new one.
Attach the ink cartridge(s) corre-
sponding with the color shown on
the display.
Remove the waste ink tank and set
an empty waste ink tank.
Down the table by pressing the [ ]
key on the sub panel until the LCD
indicates "OK", and then start the
jog operation again.
Or remove the media from the
table and then press the [ENTER]
key.
Check the loaded ink cartridge.
Pull out the inserted cartridge and
insert it again. If the same error
message appears again on the
LCD, contact your local distributor
to call for service.