Troubles For Which Error Messages Are Given On The Lcd - MIMAKI JV4-180 Maintenance Manual

3-1. Troubles for which error messages are given on the LCD

1) Segregation of causes of errors
2) Initial remedies
3) Failures on the plotter side
4) If the error recurs even after correcting it in accordance with the specified recover-
Downloaded From ManualsPrinter.com Manuals
General recovering procedures for troubles for which error messages are given on LCD
are as follows:
Causes of errors are roughly classified into the following groups.
1) Handling errors on the system side
2) Defective conditions on the system side
3) Defective conditions on the interface cable
4) Plotter handling errors
5) Mechanical malfunctions in the plotter
6) Malfunctions in hardware of the plotter
7) Malfunctions in firmware of the plotter
Track down the cause of a trouble to the system side or the plotter side referring to the
error message shown on the LCD.
1) Check whether you have changed connection conditions (time-out setting on the host
PC, etc.).
2) Check whether or not the trouble arises under specific circumstances.
3) Check whether or not the trouble is reproducible.
Take the following recovering procedure.
1) Replace the faulty component (sensor, etc.) with a new one or properly adjust it.
2) Update the firmware.
3) Replace PCBs.
ing procedures, return the device to the factory for repairs.
– 3.2 –