Table of Contents
Advertisement
Drawing setup conditions [LIST]
This function outputs the current settings of the device.
They are useful in carrying out maintenance of the device.
1.SET UP
2.PRINT ADJUST
3.VERSION
4.PARAMETER
• When this function is used to output data commands on a sheet of paper,
use 297mm x 210mm or larger size with the long side set horizontally.
• Gap check is performed when the head gap adjustment has not been
checked. (
STEPS:
1. Set a sheet of paper, use 297mm x 210mm
or larger size with the long side set hori-
zontally, and set the Origin.
2. Select the [LIST] from the [MAINTENANCE].
(
P.5-2)
3. Press the [ENTER] key.
The list will be printed automatically.
4. Press the [END] key twice, and the device
returns to the LOCAL mode.
: Indicates a value that is specified with the FUNCTION.
: Indicates a correction value for dot position.
: Indicates the version of the firmware and memory capacity of
the device.
: Used for service engineer for maintenance.
P.2-13)
- 5-3 -
MAINTENANCE
LIST
* * LIST * *
<< LOCAL >>
< ent >
Advertisement
Table of Contents
