Preparing For The Fc1202 Installation; Required Upgrade Kits; Required Equipment (Customer Supplied); Required Tools - Quantum PX500 Series Upgrade Instructions

Quantum PX500 Series FC1202 Upgrade Instructions
81-81351-01 C01
April 2006

Preparing for the FC1202 Installation

Required Upgrade Kits

Table 1 FC1202 Upgrade
Kit PN PR-UU9CF-YF
Required Equipment
0
(Customer Supplied)
0

Required Tools

FC1202 Upgrade Procedure

4
Before beginning the installation procedure, make sure that you have the
required upgrade kit and tools.
The FC1202 installation requires the following upgrade kit for every two tape
0
drives in a PX500 Series library (see
All part numbers are subject to change without notice.
Note:
Qty Description
1 FC1202 PWA
2 SCSI Cables
1 Ethernet cable
1 Terminator
1 Quantum PX500 Series FC1202 Upgrade Instructions
A zonable Ethernet switch is required if multiple FC1202 Fibre Channel
bridges are installed in either a PX506 or PX510 library. If a single FC1202
Fibre Channel bridge is installed, an Ethernet switch is not required.
The following tools are required to install the FC1202 bridge upgrade:
• #2 PHILLIPS® screwdriver
The upgrade procedure is identical regardless of the number of FC1202s
installed except where noted. The upgrade procedure consists of the
following major steps:
•

Preparing the Quantum PX500 Series Library

•

Removing Tape Drive SCSI Jumper Cables

•

Installing the FC1202 Bridge

•

Installing the Ethernet Cables

•

Installing SCSI Jumper Cables

Preparing for the FC1202 Installation
table 1):
0
0