Sensor - FUTABA 6K Instruction Manual

Sensor

SENSOR
Function
This screen registers the telemetry sensors used
with the transmitter. When Futaba SBS-01T/E,
SBA-01RO/RM/RB and SBS-01A sensor is used,
this setting is unnecessary and the sensor can be
used by simply connecting it to the S.BUS2 port of
the receiver.
Servos are classified by CH, but sensors are classified in units called "slot". There are slots
from No. 1 to No. 31. Altitude sensors units may use multiple slots.
T6K can use 1 of temperature, RPM and altitude sensor respectively. Any more sensor can't
be used.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
（1 second）
Change the sensor
① In the SENSOR screen state, select
(sensor) from the menu with the
Jog key.
● The "SENSOR" of a menu is chosen, and Jog key
press.
was changed by other transmitters or Robbe sensor
(TEMP125, VARIO-1712, 1672), they must be
registered here.
[What is a slot?]
"SENSOR"
② Select
from the menu with the Jog
key.
② Select the sensor by pressing
the + key or – key.
＋
or
● The kind of sensors.
● OFF → R3008SB：EXT battery voltage can be indicated.
● R3008SB Receiver, CA-RVIN-700 (external voltage input cable sold
separately) is necessary.
● Soldered wiring work is necessary.
When using sensor to which the slot number
③ Open the setting screen by
pressing the Jog key.
－
● SBS-01T, SBS-01TE is used.
● SBS-01RO, SBS-01RM, SBS-01RB is used.
(Common)
85