Telemetry:temp - FUTABA 6K Instruction Manual

TEMP : Display of SBS-01T/TE(Option), and alarm setup
TEMP is a screen which displays/sets up
the temperature information from an optional
temperature sensor.
The temperature of the model (engine, motor,
battery etc.) which is flying can be displayed.
If it becomes higher or lower than the setting an
alarm and/or vibration will ALARM you.
● Select [TMP] in the TELEMETRY screen and access
the setup screen shown below by press the Jog
key.
● "UP" will show that an
alarm will start when
the temperature rises
above the set value.
● "DN" will show that an
alarm will start when
t h e t e m p e r a t u r e
drops below the set
value.
● Y o u c a n h e a r t h e
temperature through an
earphone or headset, by
activating the Speech
function.
ALARM set : Hot warning
1. Move the cursor to the UP:(ALARM) item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT)[value]item.
4. Ajust the rate by press the +-key.
Initial value: +100℃
Adjustment range: -20℃ ~200℃
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
*A temperature sensor must be installed in the aircraft.
● Conversion of a display unit is performed by "TLM UNIT"
of "PARAMETER".
● Temperature
● Switch selection
OFF
OFF
ON
2 Position
ALARM set : Low-temperature warning
1. Move the cursor to the DN:(ALARM) item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the DN:(LIMIT)[value]item.
4. Ajust the rate by press the +-key.
Initial value: 0℃
Adjustment range: -20℃ ~200℃
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
● The maximum and the minimum
when powering ON are shown.
● Maximum and minimum
by pressing the Jog key for 1 second.
"VIB" type
If the following types are selected, the
transmitter will vibrate during the warning.
TYPE 1
TYPE 2
TYPE 3
OFF
ON
3 Position
date reset
81