S.BUS2 SYSTEM
When using the S.BUS2 port, an impressive array of telemetry sensors may be utilized.
Receiver port
S.BUS
S.BUS2
S.BUS servos and gyros and S.BUS2 servos and gyros must be used in the
correct receiver ports. Please refer to the instruction manual to make sure
you connect to the correct one.
Connection is possible
Connection is possible
Connection is impossible
44
S.BUS2 TABLE
S.BUS Servo
S.BUS Gyro
○
× (※)
(※) Don't connect S.BUS Servo,
S.BUS Gyro to S.BUS2 connector.
CH Mode is set to ModeB.
HUB
S.BUS Servo
S.BUS2 servo
Connection is impossible
S.BUS2 gyro
Telemetry sensor
S.BUS2
Servo
S.BUS2
Gyro
○
○
HUB
HUB
S.BUS2 Servo
S.BUS servo
S.BUS2
GYRO
+
Rudder Servo
Telemetry sensor
×
○
HUB
Telemetry
Sensor