Elevon; Elevon; Wing Type - FUTABA 6K Instruction Manual

Elevon

ELEVON

Function
This mixing is used with delta wing, tailess, and
disk shaped airplanes that combine the aileron and
elevator functions.
Connect the CH1 servo to the left aileron and the
CH2 servo to the right aileron.
●The aileron and elevator travel can be adjusted
individually.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
Aileron1 （ CH1） rate
Aileron2 （ CH2） rate
Elevator2 （ CH1） rate
Elevator1 （ CH2） rate
● Select the setting item with
the Jog key.
ELEVON
■ Activating the function
① Select the "ELEVON" by WING
type (MDL TYP).
NOTE：We recommend that setting be performed while moving the stick and checking the amount of
movement. If the amount of movement is too large, elevator and aileron operation will be compounded and the
servo travel range will be exceeded and a dead band in which the servo will not operate may be created.

WING TYPE

1AIL
CH2
"ELEVON"
② Select
from the menu with the
Jog key.
■ Rate set
② Select the "RATE" item and then adjust
the mixing rate by pressing the + key or
– key.
Range：-120 ～ +120%
Default：+100%
（only ELE1 : -100%）
● When you want to return the set value to the initial value, press
the + key and – key simultaneously. However, polarity does not
return.
(AIRPLANE)
1AIL1FLP 2AIL 2AIL1FLP ELEVON
CH2
CH1
Pitch (Elevator operation)
CH1
Roll (Aileron operation)
③ Open the setting screen by
pressing the Jog key.
Select the Left/
R i g h t w i t h t h e
aileron stick .
（Aileron rate）
L：Aileron stick Left side rate
R：Aileron stick Right side rate
（Elevator rate）
＋ －
or
111